How To Make Crack (common method)

This is the most common method. Get a spoon and mix 2 parts of cocaine hydrochloride (regular cocaine) to 1 part baking soda in some water.

Heat solution gently (with a lighter or candle) until white precipitates form, and stop heating when precipitation stops.

After gentle heating, the freebase cocaine will float to the top, any excess soda will settle on the bottom.

Collect the compound that rises to the top, and you have the finished product, ready to use.

What you're trying to do is start and sustain a chemical reaction (bonding the hydrochloride with the base-soda) so as long as the reaction is happening you don't have to continue heating.

I want first to express my personal opinion that freebasing is
a very bad thing to do for your body and mind. I have seen a few
people hooked on it, and it is not a nice thing to see. I strongly
disrecommend doing it. It is easy to overdose and die of cardiac
arrest. Some people doing freebase will exhibit the same kind of
behavior as those rats whose pleasure centers are electrically
stimulated: they will do it until either the supply runs out, or until
they die.

The recipes are readily available. In fact, a few years ago,
police officers would go to great lengths explaining how crack was
made when given interviews (at least in Montreal)! There was also an
article in Time a few years ago explaining the procedures.

I have never tried any of those procedures or smoked freebase,
and will never do it. The information I post comes from a used booklet
I bought a long time ago ("Cocaine Handbook", by Davis).

Crack is actually an impure form of freebase. Procedures for
both substances are based on the fact that while cocaine hydrochloride
is very soluble in water, base cocaine is almost insoluble.

freebase:

mix about 1 g of coke in 10 ml of water in a small vial.
Slowly add drops of ammonia to the solution. A white milky precipitate
will form. Stop adding ammonia when additional drops no longer result
in precipitation. Add 5 ml of ethyl ether, close vial, and shake. The
precipitate (freebase) will dissolve in the ether. Siphon off the
ether with a pipette (ether and water don't mix), and slowly drip it
on a plate. As the ether evaporates, white crystals will form. This is
the evil freebase. Crush the crystals and put under a heat lamp for at
least 24 hrs to let the solvent evaporate.

ETHYL ETHER IS EXTREMELY FLAMMABLE. IN THE PRESENCE OF AIR IT
CAN FORM PEROXIDES WHICH WILL SPONTANEOUSLY EXPLODE! ALSO, ETHER CAN
"CRAWL" FROM AN OPEN BOTTLE AND TRIGGER AN EXPLOSION MANY FEET AWAY.

This is how Richard Pryor almost died. A lot of untrained
people killed themselves doing that procedure, and this is why crack
is now more popular.

crack:

mix 2 parts ok coke HCL for 1 part baking soda in 20 ml of
water. Heat solution gently until white precipitates form, and stop
heating when precipitation stops. Filter and keep precipitate. wash
precipitate once with water (this procedure usually omitted in street
product). Dry 24 hours under heat lamp. Voila. The product is much
less pure (there is lots of baking soda left) but the procedure is
safer.

ble litt usikker her, trenger men ikke å blande bakepulver/natron oppi ?

Fungerer også helt fint å bare røyke colaen som den er. Kakke den opp og legge oppå aska i ei pipe, og så bare fyre og trekke dyyyypt.

HERREGUD!!!!!!!!!! Cocke suge å Crakk lages lettest ved å varme pulvere å presse som faen med fingrene

Har hørt at man skal røre et halvt gram i en spise-skje med amoniakk,å samle opp steinene/krystallene med en q-tip. Er dette sant? Eller er det enklere metoder?

Takker for svar. Var ikke crack jeg var ute etter å røyke, men freebase.

Bare lurer. Hvis man skal lage crack av kokain, skal man da bruke bakepulver eller natron pulver?? Har hørt forskjellig.